Accessories for CAN bus measurement modules

Cables

Our cables for networking and power supply of the CAN Bus Modules are especially manufactured for CSM. They are designed for high interference resistance and a very low internal resistance of the supply lines.

The specified temperature range is -40°C up to +150°C (-40°F up to +302°F) (exception K45). The cables are flexible and have a very well chemical resistance including fuel and oil.

Mounting parts

The CSM MiniModules can be fixed easily with cable ties.

CSM offers also universal mountings for up to 8 MiniModules, as well as a special rack for top hat rail mounting.

Direct to

Power Switching MiniModule

Power Switching
MiniModule

Central power distribution for the entire measurement system
Switching on and off selectively of measurement modules, data logger and further external devices
Configurable gate input: KEY_ON, switching voltage by the data logger, external voltage
Operating temperature: -40 °C to +85 °C
Robust aluminum housing: IP50
Very compact design, adapted to CSM MiniModules

Data_Sheet

Cables for measurement modules

K73-0250

Interface Cable CAN & Supply for MiniModules

Connection cable for the CAN Bus interface of the PC with power supply for the CSM Modules.

5-pole plug on D-Sub coupler

K74

CAN Termination Plug for MiniModules

The last MiniModule on the CAN Bus is terminated with this plug.

5-pol plug with 120 Ohm resistor

K70-xxxx

Connecting Cable for MiniModules

Connection cable for CSM MiniModules. The Connection Cable is available in lengths as follows: 25cm, 50cm, 1m, 2m, 5m and 10m.

Both endings 5-pole plug

K72-0250

Connection Cable & Supply for MiniModules

Connection cable between the modules with additional power supply.

Both endings 5-pole plug

K71

Cable Coupler for MiniModules

Connects two Connection Cables K70-xxxx. Thus each necessary cable length is possible.

Both endings 5-pole female connector

K77-0250

Interface Cable ES690 & Supply for MiniModules

Interface cable for CAN Bus interface of ETAS ES690 with power supply for CSM MiniModules.

5-pole plug on 10-pole plug

K45

Connection Cable K45 for xx-Scan modules

Connection cable to CAN Bus interface of ETAS ES690 for connection with AD-/Thermo-/Dual-Scan CAN and MiniModule K73-0250 Interface Cable.

10-pole plug on D-Sub plug

Sensor Cable

Sensor Cable

Sensor Cable for AD-MiniModules

Connection cable between AD-Scan MiniModul and sensor with plugs for sensor power supply.

6-pole plug on banana plug / coupler

K106

Sensor Cable for AD-Scan MiniModules

Connection Cable between AD-Scan MiniModule and a sensor with plugs for positive and negative sensor power supply.

6-pole plug on banana plug / coupler

K114

Sensor Cable for AD-Scan MiniModules for current measurement

Connection cable between AD-Scan MiniModule and sensor with plugs for sensor power supply .